3.16 - Chromatography
No description yet. This curated deck is ready for daily study.
Card preview (24)
If the Stationary Phase is a Liquid, Separation occurs by ____ ?
Relative Solubility
Uses of GC (Gas Chromatography)?
Separate Components - particularly volatile ones low boiling points
Stationary Phase: GC (Gas Chromatography)?
Solid or Solid coated with Liquid packed into a capillary tube
Limitations of GC (Gas Chromatography)?
|> Many similar compounds have the same Retention time |> Peaks of higher concentrations can hide peaks of lower concentrations |> Unknown compounds have no Reference values
Stationary Phase: CC (Column Chromatography)?
Solid packed in a glass column
Properties that affect Strength of Adsorption & Relative Solubility?
Charge Polarity Chirality Size
Mobile Phase: CC (Column Chromatography)?
Liquid solvent (eluent) moves down the column
Uses of TLC (Thin Layer Chromatography)?
Check Purity of Compounds
Stages of GC-MS
|> GC is first used to separate components in the mixture |> Each separated component is directed to the mass spectrometer in turn |> Each mass spectrum can be analysed or compared with a spectral database |> Each component can be identified |> Quantity of each component can be determined
Stages of GC (Gas Chromatography)?
|> Mixture is injected into Gas chromatograph where it vapourises |> Carrier gas flushes mixture through the column |> Components slow down as they interact with the stationary phase |> Each component leaves the column at a different time & is detected
Stages of CC (Column Chromatography)?
|> Fill a Glass tube w/ stationary phase, held by a filter or mineral wool plug |> Cover all powder in solvent |> Dissolve the mixture to be sampled in minimum amount of solvent |> Place mixture on top of solid phase |> Run mixture through column by opening tap & adding solvent |> Time taken for each component to reach end of column is recorded = retention time
Stages of TLC (Thin Layer Chromatography)?
|> Dissolve small sample of mixture in solvent |> Draw pencil line @ bottom of TLC plate |> Place small spot of sample on pencil line, allow to dry |> Place TLC plate in a beaker containing small amount of solvent - below pencil line |> Cover with a lid |> Allow solvent to rise |> Once solvent has risen almost to top of plate, remove & mark solvent front |> Use a locating agent to make compounds visible
Mass Spectrometry is used to ____ the separated components by ____ ?
Identify Comparing Mass spectra to a Database
Examples of Locating Agents?
|> Ninhydrin |> UV Light |> I₂ |> KMnO₄
Why is a Locating Agent useful for TLC (Thin Layer Chromatography)?
Make Compounds Visible)
Advantages of CC (Column Chromatography)?
Fairly large amounts can be separated
Advantages of TLC (Thin Layer Chromatography) compared to Paper Chromatography?
|> Better Resolution |> Faster |> Smaller amounts of Samples needed
Mobile Phase: GC (Gas Chromatography)?
Unreactive Gas passes through column @ high pressure & high temp
If the Stationary Phase is a Solid, Separation occurs by ____ ?
Adsorption
The Stronger the Adsorption to the Stationary ____ phase the ____ the component moves through the ____ phase?
Solid Slower Mobile
What is a Mass Spectrum?
Plot of Relative Abundance against Mass to Charge Ratio (m/z)
In a Mass Spectrum, Peak with Highest m/z is due to the ____ ?
Molecular ion M⁺ Peak Gives Mr
Limitations of TLC (Thin Layer Chromatography)?
|> Unknown compounds have no Rf values for reference |> Similar compounds have similar Rf values |> Can be difficult to find a solvent that gives good separation
Define: Rf
Rf = Distance moved by spot/Distance moved by solvent